2004 Ford F-150 Rear Axle Differential Cover Axle Shaft Oil Seal and Rear...
download 1. With the vehicle in NEUTRAL, position on a hoist. For additional information, refer to Section 100-00. 2. Remove the rear wheel and tire assembly. For additional information, refer to...
View Article1997 Ford Aerostar/Ranger Wheel Grease Seal and Bearing Front Replacement and...
download The recommended wheel bearing lubricant is lithium-base High-Temperature Constant Velocity Joint Grease E43Z-19590-A or equivalent meeting Ford specification ESP-M1C207-A. CAUTION: Sodium-base...
View Article1997 Ford F-250/350/Super Duty Front Wheel Grease Seal and Bearing...
download CAUTION: Use of incompatible bearing lubricant could result in premature lubricant breakdown. The recommended wheel bearing lubricant is the lithium-base grease High Temperature 4×4 Front Axle...
View Article1998 Ford Contour Camshaft Removal Installation
download CAUTION: The maximum amount by which the engine management system will adjust the camshaft timing (VCT control unit) is limited to 2 degrees. As a result of this an extremely high degree of...
View Article1996 Ford Aerostar/Ranger/Explorer Camshaft Position (CMP) Sensor REMOVAL AND...
download CAUTION: Syncro Positioning Tool T95T-12200-A (3.0L, 4.0L) or T96T-12200-A (5.0L) must be obtained prior to installation of the replacement synchronizer assembly. Failure to follow this...
View Article1991 Mercedes Benz 300E Camshaft: Service and Repair Removing and Installing...
download CAUTION: If the camshaft is renewed, the rocker arms must also be renewed. Inductively hardened camshafts must only be used with hard chrome-plated rocker arms (standard up to February 1989)....
View Article1998 – 1999 Toyota Camry & Toyota Solara inoperative Vapor Pressure Sensor 3...
download Introduction Under certain driving conditions, some 1998 – 1999 model year Camry and Solara vehicles may exhibit a M.I.L. “ON” with DTCs P0440, P0441 and P0446 stored due to an inoperative...
View Article1998 Ford Windstar Camshaft Position (CMP) Sensor REMOVAL AND INSTALLATION
download CAUTION: Prior to removal of the camshaft position sensor (CMP sensor) (12126) , set cylinder No.1 to zero degrees top dead center (TDC) of compression stroke. Then note the position of the...
View Article1994 Toyota Camry DX TOYOTA’’2.2L 4-Cylinder – Gasoline TIMING BELT REMOVAL &...
download 1. Disconnect negative battery cable. Raise and support vehicle. Remove lower engine cover. On Celica and Camry, remove right front wheel. On all models, lower vehicle. 2. On MR2, remove right...
View Article1995 Ford Mustang Camshaft Position (CMP) Sensor Removal Installation
download 1. Disconnect battery ground cable (14301) . 2. Disconnect fuel charging wiring (9D930) from distributor stator (12A112) (camshaft position sensor). 3. Remove stator camshaft position sensor...
View Article
